‘microsoft’ Windows: NTFSF or File-system Integrity, Security And File Sharing Features

NTFS is a Microsoft Windows file system that has volume consistency by using transaction lumber and healing methods. NTFS is able to utilize its log file and checkpoint information to bring back the consistency of the file system.

In Windows 2000 and Windows XP, NTFS also provides advanced features like file and folder permissions, disk quotas, encryption, and compression.

Unfortunately volumes usually are not always set up with NTFS as the file system. For instance the FAT file process, a file system which has a data system referred to as a File Allocation Table (FAT) to coordinate and handle documents, is commonly used as the default file system to make sure compatibility with older operating systems such as DOS; IBM OS2; and Microsoft Windows 3.1, 95, ninety eight and ME that could be on the community.

Another file system that could be placed on Windows 2000 or Windows XP is considered the FAT32 file system. The FAT32 file process is a by-product of the FAT file system. FAT32 supports smaller group sizes and much larger volumes than FAT, which results in better space allocation on FAT32 volumes.


Due to the consistency and security options that come with NTFS you may wish to turn from the FAT32 or FAT file system to NTFS. Microsoft provides a command line utility to accomplish this, appropriately referred to as “Convert”. Bear in mind that “convert” is one way only. You will not have the means to restore your volume to FAT32 or FAT without using a third party utility or perhaps by reformatting the drive.

In order to convert FAT32 or FAT volumes To NTFS, type “convert DRIVE:/fs:ntfs /X” on the command type in which “DRIVE” is the drive letter (e.g. turn C: /fs:ntfs /x).

“convert C:” shows the command to turn the volume that are on the specified drive, in this case the C drive. “/fs:ntfs” tells the command to change to the NTFS file system. The “/X” parameter” is going to force the volume to unmount first.

In case you are trying to convert your primary volume within Windows, turn will not be able to receive exclusive access to your hard drive. In other words, while XP is operating a few documents on your primary volume are always “in use”, and so the transformation must be achieved the next time Windows actually starts to load.

On the following reboot the process is going to check the drive for errors before proceeding to convert the file system to NTFS.

if the above conversion is effective, or even if you check out the above mentioned instructions and get the point “Drive is already NTFS” however, you still do not see the “advanced share” and the “security” tab in “folder properties”, test the following:

Open Windows Explorer.

Select the Tools selection.

Select Folder Options.

Select the View tab.

Scroll the Advanced options list to the very bottom.

Now, you will see the “Use easy file sharing (Recommended)” option.

If enabled, take away the check out of the checkbox.

You should today have an “advanced a “security” and also share” tab tab in the ” folder properties” windowpane.

buy windows 10 pro key

Leave a Reply

Your email address will not be published. Required fields are marked *